Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in North Hollywood, CA
Gate access control in North Hollywood usually calls for a keypad, intercom, or card reader on a gate that was installed as a retrofit, often decades after the building went up. Most of what we repair here is 1980s and 1990s equipment wired into 1940s through 1960s construction, and Valley heat pushes those old circuit boards and transformers harder than they were ever rated for. If a gate stopped reading codes, stopped opening on a buzzer, or stopped responding to a remote, call (805) 210-8672 and we’ll send a technician who can diagnose it on site.
Why North Hollywood Homes Are Different
North Hollywood sits in the interior San Fernando Valley, where summer temperatures routinely exceed 105°F. That’s measurably hotter than coastal LA, and it changes how gate operators fail. Capacitors swell and split. Motor windings overheat and short. Control boards bake inside metal enclosures that sit in direct afternoon sun. A gate operator that might last 15 years in Santa Monica can burn through brushes and capacitors in half that time here, simply because the ambient temperature at the motor is 30 degrees higher.
The second factor is the housing stock. North Hollywood is dominated by post-WWII single-family homes and two-story stucco apartment buildings mostly built through the 1980s. Most had electric driveway and pedestrian gates added as retrofits, not original construction. That means gate posts were often anchored into existing driveways or older masonry walls that shift and crack over decades, causing chronic alignment problems, post lean, and motors that strain against bind. We see bent hinge plates and twisted operators regularly, the direct result of a post that moved a quarter inch and turned the gate’s travel arc into a binding point.
Our Main North Hollywood Services
These are the three gate services North Hollywood homeowners and building managers call about most. Each has its own page with full pricing, sub-jobs, and North Hollywood-specific detail.
Gate Repair in North Hollywood
A gate that grinds, sags, or stops mid-travel is usually repairable, but the fix has to match the failure. In North Hollywood, that often means heat-related electrical failure or post movement from long-term soil shift. We diagnose the exact fault, document it, and hand you a written price before any work starts. Gate Repair in North Hollywood covers the full process, from hinge rebuilds to control-board replacement.
Gate Installation in North Hollywood
Installing a new gate on a 1950s driveway or 1980s apartment entrance means working around existing concrete, old stucco walls, and whatever wiring is already underground. We size the gate, set posts to depth, and run the operator to current code, including entrapment protection when required. Gate Installation in North Hollywood details what a complete installation includes.
Gate Motor & Opener in North Hollywood
Motor replacement in North Hollywood almost always involves a unit that either cooked itself in the heat or was installed 25 years ago and never serviced. We work on nine major automation brands and usually keep the existing gate, replacing only the motor or the board. Gate Motor & Opener in North Hollywood explains brand compatibility, replacement options, and the written-price policy.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in North Hollywood
Gate access control in North Hollywood usually means retrofitting a keypad, telephone entry, card reader, or video intercom onto a gate that was built without one, or repairing an older system that has failed from age and heat. We work on the equipment already on the property, and when a 30-year-old setup lacks entrapment protection, we tell you what California law now requires before we touch it. This is the heart of what Gate Access Control work looks like in the Valley.
Keypad Entry
Signs you need it
Codes stopped working, certain buttons don’t respond, or the keypad face is cracked and letting moisture onto the circuit board.
What it costs in North Hollywood
Replacement keypads and associated wiring typically run $280 to $650 in North Hollywood, depending on brand and whether the cable to the operator needs replacing.
How we do it
We test voltage at the keypad, check the cable run, replace the unit if needed, reprogram codes, and photograph the final wiring.
Video Intercom
Signs you need it
The screen works but won’t release the gate, audio is dead, or the camera shows nothing but a black frame.
What it costs in North Hollywood
Video intercom repair or replacement in North Hollywood generally falls between $350 and $1,000 depending on indoor monitor count and wiring condition.
How we do it
We test each leg of the system, replace the failed station or cable segment, re-terminate the connections, and leave a documented photo record.
What Gate Access Control Costs in North Hollywood
| Item | Typical range in North Hollywood |
|---|---|
| Keypad replacement | $280 - $650 |
| Telephone entry system repair | $250 - $600 |
| Video intercom repair or replacement | $350 - $1,000 |
Can you upgrade an old apartment gate to code in North Hollywood?
Yes. Older North Hollywood apartment gates often lack the photo-eyes and reversing-edge sensors California now requires. We install compliant entrapment protection while retaining the existing operator where possible, and we photograph everything we change.
Do you work on access control for a single-family gate in North Hollywood?
Yes. We retrofit keypads and intercoms onto single-family driveway and pedestrian gates throughout North Hollywood, typically finishing in a single visit. Call (805) 210-8672 for a written quote.
Gate Parts & Welding in North Hollywood
Gate parts and welding in North Hollywood is usually about correcting what the soil and heat started. Post lean, cracked welds at the hinge, and rollers ground down by Santa Ana dust are all routine here, and we handle it under one service. Our Gate Parts & Welding work always comes with a written price and a photo record of what we changed.
Hinge Replacement
Signs you need it
The gate sags toward the latch side, scrapes the ground, or the hinge plates show visible cracking at the weld or bolt line.
What it costs in North Hollywood
Hinge replacement in North Hollywood typically costs $180 to $480 per hinge set, depending on gate weight and whether welding is required.
How we do it
We support the gate, remove the old hinges, weld or bolt the new set, and adjust travel so the gate closes square.
Post Replacement
Signs you need it
The post leans visibly, the gate drifts open or closed on its own, or the post concrete has cracked and pulled away from the surrounding slab.
What it costs in North Hollywood
Post replacement in North Hollywood usually runs $350 to $900 per post, including concrete removal and new anchoring.
How we do it
We cut and remove the old post, set a new one to depth in fresh concrete, re-hang the gate, and verify the travel arc.
What Gate Parts & Welding Costs in North Hollywood
| Item | Typical range in North Hollywood |
|---|---|
| Hinge replacement | $180 - $480 per set |
| Post replacement | $350 - $900 per post |
| Custom welding repair | $150 - $500 |
Can you weld a cracked gate frame in place, or does it have to come down?
Most cracked frames can be welded in place. We clean the area, weld the crack, and often add a gusset plate to stop it re-cracking at the same point.
How long does post replacement take in North Hollywood?
One post usually takes half a day including concrete cure time under normal Valley conditions. The gate hangs the same day. Call (805) 210-8672 for a written price.
Brands We Service in North Hollywood
We service LiftMaster, FAAC, BFT, and Linear operators most often in North Hollywood, and we keep common boards, remotes, and capacitors for those brands on the truck. See our brands for the full list of nine manufacturers we support, with same-day parts availability on most common repairs.
Pricing for Gate Repair in North Hollywood, CA
| Service | Typical range in North Hollywood |
|---|---|
| Gate repair diagnostic visit | $85 - $150 |
| Hinge replacement | $180 - $480 per set |
| Post replacement | $350 - $900 per post |
| Rail repair | $200 - $600 |
| Gate roller replacement | $150 - $400 per set |
| Gate operator / motor replacement | $450 - $1,200 |
| Keypad replacement | $280 - $650 |
| Telephone entry system repair | $250 - $600 |
| Video intercom repair or replacement | $350 - $1,000 |
| Custom welding repair | $150 - $500 |
Two things push gate pricing up in North Hollywood more than anything else: heat-damaged circuit boards on older operators, and post movement from decades of soil shift under retrofitted gates. Whatever the final number, you get it in writing before we pick up a tool, and that written price is what you pay.
Neighborhoods We Serve in North Hollywood
We cover all of North Hollywood, from the apartment-dense blocks near Burbank Boulevard to the single-family streets north of Magnolia and the NoHo Arts District. Most repair calls in the area get a same-day or next-day visit.
- NoHo Arts District
- Valley Village
- Toluca Woods
- Amelia Earhart area
- West North Hollywood
Service Area - Cities Near North Hollywood
Vance Gate Repair covers North Hollywood and the surrounding Valley and metro neighborhoods, including Studio City, CA, Van Nuys, CA, Sherman Oaks, CA, and Beverly Hills, CA. If you’re just outside these borders, call and ask; our Los Angeles office dispatches crews throughout the Valley.
Serving North Hollywood, CA - Our Local Coverage Area
We’re based in the North Hollywood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in North Hollywood
Most North Hollywood repair calls get a same-day or next-day visit, depending on the failure and the time of day. Emergency calls are dispatched 24/7, and a live person answers at (805) 210-8672 at any hour.
Replacing a post on an existing gate generally doesn’t require a permit. New gate installation or major electrical work may, and we tell you before any work starts if your project will need city approval.
Yes. We work on apartment and HOA gate systems throughout North Hollywood, including older complexes where the operator predates current entrapment-protection law. We document every repair with photos and a written scope, which most boards want anyway.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What North Hollywood Customers Say
"Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."They installed the opener and left me a diagram of the wiring and the limit settings. When I needed a second remote programmed I could do it myself."
- Nadine C.